802.589.0911 Live Chat With Us

Best Selling Genuine Mercury Turn Signals

  • We Stock the following top leading brands, including
  • Constantly Updated Inventory of Mercury Replacement Turn Signal Parts

We stock Turn Signal parts for most Mercury models, including .

Sorry, no results were found.


Latest Mercury Repair and Turn Signal Installation Advice

CarJunky AutoAdvice

Left turn signal on 1987 Mercury Sable car won't work

Showing 2 out of 2 Posts
Question From Guest on Left turn signal on 1987 Mercury Sable car won't work

The left turn signal on a 1987 Mercury Sable car won't work but the right turn signal will and seems like if the sensor thing was wrong with it then the right turn signal would not work. Any idea what could be wrong? Do you think that the bulbs on that side may be burnt out?

Response From Tom Greenleaf Top Rated Answer

Try the four way hazzard lights and see if the bulbs light. Should be same filiment of the bulbs. Would be odd that two went out at once but possible. Check at the sockets if 12v get's there if they look good,

T

I need to install the turn signal/brake light for the rear of my 02 Mercury Mountaineer

Showing 3 out of 3 Posts
Question From Guest on I need to install the turn signal/brake light for the rear of my 02 Mercury Mountaineer

I need help removing the housing of the brake lights so I can replace the bulbs for the brake/turn signal on my 02 Mercury Mountaineer.

Response From way2old

Open the rear hatch. There are 2 phillips head screws beside the light housing. Remove these. Then pull the light assembly away from the body. It may be a little hard to get it out, but it will come out. Then twist the light socket out of the assembly and remove bulb.

Response From Tom Greenleaf Top Rated Answer

Many vehicles use fasteners from the inside of the vehicle. To access the back of the lense you probably have to remove trim parts and you shouldn't have to remove the lense to replace the bulb. Try not to touch the glass of bulbs. Use paper handling the new ones as the oils from your hand can cause early failure.

That's mandatory with halogen headlight bulbs. If a bulb has blown and you believe they are the same age it's best to do both sides as they generally go close to the same time, T

1996 Mercury Cougar xr7 coupe - turn signal/brake light

Showing 7 out of 8 Posts | Show 1 Hidden Posts
Question From RoyMustang on 1996 Mercury Cougar xr7 coupe - turn signal/brake light

1996 mercury cougar xr7 coupe
3.8
127,000

Hi there, last night I was hit in the rearrend at a red light, pretty hard but only my bumper was scratched. Recently after I discovered my turn signals weren't working, nor my brake lights. My dad checked the fuse and it's fine, and I put new bulbs and they still aren't working.. could anyone have any suggestions please?

Response From Hammer Time

Is the 3rd (high mount) brake light working?

Response From RoyMustang Top Rated Answer


Is the 3rd (high mount) brake light working?

Response From Tsewell

yes

Response From Hammer Time

yes

FAIL!

Response From Hammer Time

Well?

Response From RoyMustang

uh i posted no, guess it didnt copy.. sorry, no it's not working either.

Response From Hammer Time

Your going to have to check your wiring harness going to the rear of the car. That 3rd brake light is on a different circuit than the other lights so if they are all out, it has to be in the harness, assuming it worked before.

Turn signals not working

Showing 2 out of 2 Posts
Question From Guest on Turn signals not working

Turn signals and hazzards are not working on 1998 mercury marque-fuses are good and have been changed-back up light on the same cuircuit are working-any help?

Response From way2old Top Rated Answer

More than likely it is the multifunction switch (turn signal switch) There are a known failure on Ford progucts.