Shop Discount Turn Signals

how do u replace front turn signal blub on a 2004 cts?

Headlamp Assembly or Headlamp Bulb and/or Cornering, Sidemarker, Park, Turn Signal Bulb Replacement

1. Raise and support the vehicle.
   
   
   
2. Remove the push-pin retainers on the air deflector to allow access to fascia extension retainers.
3. Open the hood.
4. Remove the push-pin retainers that secure the appropriate side of the grille and fascia to the upper tie bar.
5. Remove the first push-pin retainer past the center in order to allow the grille to flex.
   
   
   
6. Remove the front fascia extension.
   
   
   
7. Remove the bolt (2) that secures the front fascia to the fender.
8. Loosen the bolt (1) that attaches the front fascia to the fender.
9. Pull the front fascia forward to align the fascia studs with enlarged portion of the hole within the key slot in the fender.
10. Gently pull the front fascia downward to disengage it from the front fender.
    
    
    
11. Remove the 3 bolts that secure the headlamp to the vehicle.
12. Disengage headlamp washer hose, if equipped.
    
    
    
    Important: A high amount of force is necessary to perform the next step.
13. Pull the headlamp straight forward to disengage the headlamp ball stud from the fender socket.
14. Reach behind the headlamp to disconnect the headlamp electrical connector.
15. Pull the top part of the front fascia and grille assembly forward only far enough to remove the headlamp assembly from the vehicle.
16. Remove the headlamp assembly from the vehicle.
17. Remove the headlamp bulb cover from the headlamp assembly.
    Caution: Halogen bulbs contain gas under pressure. Handling a bulb improperly could cause it to shatter into flying glass fragments. To help avoid personal injury: • Turn off the lamp switch and allow the bulb to cool before changing the bulb. • Leave the lamp switch OFF until the bulb change is complete. • Always wear eye protection when changing a halogen bulb. • Handle the bulb only by its base. Avoid touching the glass. • Keep dirt and moisture off the bulb. • Properly dispose of the used bulb. • Keep halogen bulbs out of the reach of children.
    
18. Remove the headlamp bulb from the headlamp assembly.

Most are accessed from behind the lense. Getting to it is another story,

T

Turn signals and hazzards are not working on 1998 mercury marque-fuses are good and have been changed-back up light on the same cuircuit are working-any help?

More than likely it is the multifunction switch (turn signal switch) There are a known failure on Ford progucts.

98 olds aurora the turn signals don't work side light goes on when i move the turn signal arm

Loren - you know the protocol. It's clearly a case of not using the synthetic blinker fluid. You know the regular stuff just doesn't last - Gees!



I think Todd can handle it from here if we leave him alone,



T

very nice lol very nice

Hey, we're only here to help.

My turn signal will make a buzzing sound when using it to turn, then work for a couple of clicks then just buzz. I replaced my turn signal flasher (EP27). Then the turn signals will work but it buzzes when the turn signal is not on. I have left to old flasher unit in to avoid constant buzz. Checked fuses, no problem there. Any Help?

have found that the turn signal relays in jeeps go bad though there r kinda expensive

My brake lights and turn signals do not work on my neon, its a 96. Any advice?? Is it worth spending the money getting fixed. The turn signals blink fast like the bulbs are out but, that is not the case.

WHEN I USE THE TURN SIGNAL IT BLINKS FAST ON THE DASHBOARD. BUT DOES NOT WORK ON THE OUTSIDE OF THE CAR.