Finish Selecting Your Vehicle to Shop For Your Radiator Hose

Choose a Year for your Peugeot 's Radiator Hose

  • 1991
  • 1990
  • 1989
  • 1988
  • 1987
  • 1986
  • 1985
  • 1984
  • 1983
  • 1982
  • 1981
  • 1980
  • 1979
  • 1978
  • 1977
  • 1976
  • 1975
  • 1974
  • 1973
  • 1972
  • 1971

Shop By Brand

The Following brands are available based on your search.

  • Dayco
  • Gates

Best Selling Genuine Peugeot Radiator Hoses

  • We Stock the following top leading brands, including Gates
  • Constantly Updated Inventory of Peugeot Replacement Radiator Hose Parts

We stock Radiator Hose parts for most Peugeot models, including 505, 604.

1982 Peugeot 505 Radiator Coolant Hose - Lower - Engine To Pipe 4 Cyl 2.3L Gates

P311-2E59201    21634  New

Gates Radiator Coolant Hose  Lower - Engine To Pipe
  • Coolant Hose - Molded
  • Molded Coolant Hose
Brand: Gates
Additional Fitment Information:
Vehicle Block CC CID Fuel Type Position
1982 - Peugeot 505 L 2304 - DIESEL Lower - Engine To Pipe
1979 Peugeot 504 Radiator Coolant Hose - Lower 4 Cyl 2.0L Gates

P311-02E5A71    20065  New

Gates Radiator Coolant Hose  Lower
  • Coolant Hose - Molded
  • Cut to fit
  • Molded Coolant Hose
  • Suggested Purchase Quantity: 2
    • Most jobs typically require 2 of this item.
Brand: Gates
Additional Fitment Information:
Vehicle Block CC CID Fuel Type Position
1979 - Peugeot 504 L 1971 - GAS Lower

Latest Peugeot Repair and Radiator Hose Installation Advice

CarJunky AutoAdvice

Water Temp Gauge Pod Problem

Showing 6 out of 6 Posts
Question From dafatkid88 on Water Temp Gauge Pod Problem

Hiya peeps.. I'm new to this site so please bare with me..

I've just Installed a water temp gauge pod in my 1999 Peugeot 206 1.6glz using an upper radiator hose adapter for the 1/8 sender to screw into but have noticed that once the thermostat kicks in and the sender starts picking up on the temp it shows the coolant is at around 98 - 110 degrees celcius yet the dash temp gauge only says its about 85 - 90 degrees.. Is it normal for the upper radiator coolant temp to be hotter?

Cheers for any suggestions you may have :)

Response From Hammer Time

Why on Earth would you install a temp sender after the thermostat. You will not get accurate coolant temps there.

Response From dafatkid88

I installed it there because that was where the instructions suggested.. Am thinking now it would be better to get a t piece and install it with the oem sender.. Would this give an accurate reading? Cheers

Response From Tom Greenleaf Top Rated Answer

Get the right sender and replace the broken original. You plain wont get accurate info AFTER the t-stat. May take a tool to remove the broken sensor/sending unit and if up high you don't need to totally drain cooling system - just low enough to not make a mess,


Response From dafatkid88

Ok Cheers Guys :) I'll Let Ya Know How I Get On

Response From Tom Greenleaf

This vehicle not sold where most regulars are here. No matter. I'm guessing you are talking about a sender for temp into to dash view. If not in the proper location all bets are off. Why did it require moving?