P311-04E17C8 26-1618 New
442500C010 , 442500C030 , 442500C041 , 442500C050 , 4550309120 , 4550309240
- with Hydraulic Power Includes Inner Tie Rods For warranty purposes it is recommended to always install a filter and to use suggested OE Fluid and flush the system In-Line Filter available
- Remanufactured Rack and Pinion Assembly
- Product Attributes:
-
- Bellows Color: Black
- Contains Electronic Components: No
- Does it require SDS: No
- E-Waste: No
- End To End Length:
- 1250.95
- 49.25
- FAA_A1: The Most Likely Cause Of A Power Steering Pump Whine Is Air In The System. The Steering System Must Be Bled. This May Take A Few Attempts Depending On The Design Of The System.
- FAQ_Q1: I Replaced The Rack And Now The Power Steering Pump Is Whining. It Never Did This Before! What Happened?
- FAQ_Q2: The Steering Wheel Is Not Returning To Center Coming Out Of A Turn. What Could Be Causing This?
- FAQ_Q3: The Replacement Rack And Pinion Is Installed And The Steering Wheel Has Too Much Play. Should I Adjust The Rack?
- FAQ_Q4: Are There Any Steps That Should Be Done Prior To Alignment?
- Gasket Or Seal Included: Yes
- Grade Type: Regular
- Inlet Line Fitting Diameter:
- 0.459
- 11.66
- Inlet Line Fitting Gender: Male
- Inner Tie Rods Included: Yes
- Input Shaft Type: Grooved
- Is Item A Chemical: No
- Is Or Contains A Battery: No
- Is Or Contains A Bulb: No
- Is Prop Sixty Five Affected: No
- Is the item CARB affected: No
- Mounting Brackets Included: No
- Mounting Hardware Included: No
- Mounting Hole Quantity: 2
- Outer Tie Rods Included: No
- Outlet Line Fitting Diameter:
- 0.663
- 16.84
- Outlet Line Fitting Gender: Male
- Product Condition: Remanufactured
- Steering Input Shaft Diameter:
- 0.754
- 19.15
- Steering Input Shaft Spline Quantity: 36
- Total Turns Lock To Lock: 3.375
-
Features:
- Protective coating applied to each unit to extend the life of the unit (where applicable).
- 100% performance testing to ensure perfect fit, function and reliable performance.
- 100% hydraulic testing for proper flow, leakage and performance ensures perfect fit and function (where applicable).
- Racks are surfaced to precise specifications to prevent leaking between chambers and extend unit life.
- 100% new O.E.- style o-rings and lip seals ensure leak-free and long-lasting performance (where applicable).
- All new spool valve seals and rack donut seals are installed to eliminate internal leaks and ensure reliable performance (where applicable).
- Valve housings have polished micro-finish sleeves for durability (where applicable).
- As a remanufactured Original Equipment part, this unit guarantees a perfect vehicle fit.
- Our remanufacturing process is earth-friendly, as it reduces the energy and raw material needed to make a new part by 80%.
- CARDONE Remanufactured Rack & Pinions are re-engineered, built and tested to meet or exceed O.E. fit and performance. 100% new, O.E.-style o-rings and seals are installed to ensure leak-free, long-lasting performance. A final protective coating is applied and each unit is tested to guarantee a perfect fit and function.
