P311-07F9068 77-3494F Remanufactured
16263494 , 8162634940
- with Original Equipment (OE) # 16263494 Vehicle specific Flash programming required ON or OFF the vehicle. Accurate VIN and mileage are required Vehicle specific On-Car Programming must be performed AFTER installation to prevent drivability and starting issues Knock Module must be removed from original PCM and installed in replacement PCM
- Vehicle Control Module
- Product Attributes:
-
- Connector/Terminal Configuration: Pin/male, Pin/male, Pin/male, Pin/male
- E-Waste: Yes
- FAQs:
- Chrysler Pcm's Identified With A "v" Suffix Will Need To Be Vin Programmed.
- Do All Chrysler Power Train Control Modules (pcm) Need Vin Programming?
- Do All Ford Vehicles Require A Passive Anti Theft System (p.a.t.s) Reset?
- I Replaced The Pcm In My Gm Vehicle. Do I Need To Reset The Passlock Or Passkey Vehicle Anti Theft System (vats)?
- No, Not All Ford Vehicles Require A Pats Reset. Check The Pats Chart Found On The Motorcraft Site For Your Application.
- Prior To Replacing The Original Ecm/pcm, The Installer Should Determine What Caused The Original To Fail. Common Areas That Cause Failures Are: Poor Grounds And Powers, Bad Wiring Harness, Shorted Solenoids/relays.
- The Replacement Ecm For A Ford Vehicle Won’t Start The Vehicle. Why?
- The Wrong Ecm May Have Been Installed. Verify The Ford Engineering Id Number, Found On The Ecm/pcm, Crosses To The Correct Cardone Number.
- What Steps Should I Take To Assure The Original Ecm/pcm Is Causing The Issue?
- Yes, There's A 10 Minute Procedure Utilizing A Tech 2 Scanner And A Gm Terminal Subscription. There Is Also A 30 Minute Manual Procedure That Can Be Done Without A Scanner. Refer To An Oe Approved Service Manual For Either Option.
- Features and Benefits:
- 100% Resolder Of Critical Components Ensures Superior Electrical Connections, No Intermittent Failures And Longer Product Life
- All Modules Are 100% Tested With Automated Computerized Test Equipment To Ensure Functionality And Reliable
- Guaranteed Fit And Function
- Meets Or Exceeds O.e.m Performance
- On-car Vehicle Validation Routines Ensure That Modules Meet All Form, Fit, Durability And Performance Requirements
- Module Housing Material: Metal
- Product Condition: Remanufactured
- CARDONE Remanufactured Vehicle Control Modules are engineered for quick installation and no comebacks. Each unit is engineered to meet or exceed Original Equipment Manufacturer performance. All modules are 100% computerized tested and resolder of critical components, as well as 100% replacement of common ware components, ensuring superior electrical connections.