P311-5926AB8 22-345 Remanufactured
4723885 , 5003929AA , 5003933AA , 5003933AB , 5003940AA , 5003940AB , 5017460AA , 5017461AA , 5083091AA
- with Standard Steering (SBA) Supplied without Inner Tie Rods In-Line Filter available For warranty purposes it is recommended to always install a filter and to use suggested OE Fluid and flush the system Sales Codes are found on the "Body Code" plate located on the left front side shield, wheel housing, or the upper radiator support of your vehicle with Hydraulic Power
- Rack and Pinion Assembly
- Product Attributes:
-
- Casting Material: Steel; Aluminum
- Distance Between Mounting Holes (in): 3.13
- Distance Between Mounting Holes (mm): 79.38
- E-Waste: No
- FAQs:
- For The First Few Minutes Of Driving My Car, The Steering Is Hard. Is The Rack And Pinion Bad Or The Power Steering Pump?
- I Replaced The Rack And Now The Power Steering Pump Is Whining. What Happened? It Never Did This Before!
- Steering Not Returning To Center Coming Out Of A Turn. What Could Be Causing This?
- The Most Likely Cause Of Power Steering Pump Whine Is Air In The System. The Steering System Must Be Bled Completely.
- The Rack And Pinion Does Not Return To Center By Itself. The Geometry Of The Front Suspension Causes The Wheels To Return To Center Coming Out Of A Turn. If The Vehicle Will Not Return To Center, First, Check The Front End Alignment, Then, Check For A Res
- This Symptom Is Classified As "morning Sickness". This Condition Is Caused By Teflon Sealing Rings On The Spool Valve Wearing Grooves In The Aluminum Housing Of The Rack And Pinion Resulting In An Internal Bypass Of Pressure. Once The Housing Warms Up, Th
- Features and Benefits:
- 100% Replacement Of Rubber Sealing Components.
- All New Spool Valve Seals And Rack Donut Seals Are Installed To Eliminate Internal Leaks And Ensure Reliable Performance (where Applicable).
- Application Of Specialized Lubricant(s) For Extended Life.
- As A Remanufactured Original Equipment Part, This Unit Guarantees A Perfect Vehicle Fit.
- Each Unit Undergoes A Factory Test Drive, Simulating Extreme Operating Conditions While Verifying All On-car Communications.
- Finished In Protective Coating To Prevent Corrosion And Rust.
- Our Remanufacturing Process Is Earth-friendly, As It Reduces The Energy And Raw Material Needed To Make A New Part By 80%.
- Valve Housings Have Polished Micro-finish Sleeves For Durability (where Applicable).
- Hose Port Type: O-ring
- Input Shaft Diameter (in): 0.73
- Input Shaft Diameter (mm): 18.42
- Input Shaft Length (in): 2.13
- Input Shaft Length (mm): 53.98
- Package Contents: Rack And Pinion, Sealing Kit, Instruction Sheet
- Pressure Port Thread Size: M18 X 1.5
- Product Condition: Remanufactured
- Rack Length (in): 34.63
- Rack Length (mm): 879.48
- Return Port Thread Size: M16 X 1.5
- Steering Rack Color: Black
- Thread Length (mm): 0.00
- Tie Rod Ends Included: No
- Expertly remanufactured to rigorous quality and performance standards, CARDONE Electronic Power Steering Rack and Pinions are equipped with brand-new, premium components to guarantee exceptional longevity and reliability. Each unit undergoes CARDONE’s Factory Test Drive, simulating extreme operating conditions while verifying all on-car communications. All rubber sealing components are replaced, and a specialized lubricant is applied to drastically increase longevity.
