P311-259DD09 7112 New
- Hyd.; 1500-6500rpm; Adv. Dur. at 0.050 Int/Exh 224/234 Deg.; Lift at Valve Int/Exh 0.496/0.520 in.; Lobe Seps 112 Deg.; Intake Center Line 107 Deg.;Engines Transplanted Into Uncontrolled/Pre-Pollution Vehicle Adjustable Pushrods Or Rocker Arms Required~Idle Vacuum at 1000 RPM - 12 inch~Designed For The Engine Swap Market~Not Legal For Use On Pollution Controlled Vehicles~397hp and 400 ft.-lbs. When Matched w/Manifold 7111 and Stock Iron Heads
- CAM 7111
- Performer RPM Camshaft Kit
- Product Attributes:
-
- Engine Make/Size: Olds 307-403
- Exh. Duration @ .050 in. (Deg): 234
- Exh. Duration Advertised (Deg): 300
- Exhaust Valve Lift: 0.520 In.
- Intake Duration @ 0.050 in.: 224 Degree
- Intake Duration Advertised: 290
- Intake Valve Lift: 0.496 In.
- Lifter Type: Hydraulic Flat Tappet
- RPM Range: 1000-7000
- Usage: Street/performance
- WARNING CA Proposition 65: Yes
- WARNING CA Proposition 65 Message: Warning: Cancer And Reproductive Harm P65warnings.ca.gov
-
Features:
- Designed for 1500 to 6500 RPM Performance
- Maximum Power in High-RPM with Good Low-End Torque
- Matched to Edelbrock Performer RPM Intakes
- 10 To 12 in. Of Manifold Vacuum At Idle
- More Lift And Duration Than Most Street Camshafts
- Includes Hydraulic Lifters and Assembly Lube
- Dyno-Matched/Street-Proven Performance
- Take the Guesswork Out of Camshaft Selection!
- Edelbrock part #7112 Performer RPM Camshaft is designed for small-block Oldsmobile 350-403 V-8 applications. This Edelbrock cam kit produced 397 HP & 400 ft-lbs. of torque when used with #7111 intake and stock iron cylinder heads on a 350 engine. The camshaft works well with high-performance's street applications, Performer RPM cams provide power from 1500 to 6500 rpm. This hydraulic lifter camshaft is dyno-matched to Performer RPM manifolds for high-rpm horsepower while still maintaining acceptable low-end torque. With 10 to 12 inches of manifold vacuum at idle, Performer RPM cams have more lift and duration than most street camshafts. Hydraulic flat tappet lifters are included with each Performer RPM camshaft.Camshaft Specifications:- Duration @ .050 Intake: 224 degrees - Duration @ .050 Exhaust: 234 degrees- Lift @ Valve Intake: .496"- Lift @ Valve Exhaust: .520"- Lobe Separation: 112 Degrees- Intake Centerline: 107 Degrees- Idle Vacuum @ 1000 RPM's: 12