P311-5E0203F 6E-2108 New
16112AA400
- Relearn procedure may need to be performed upon installation of unit. Please refer to the service manual for vehicle specific instructions.
- Fuel Injection Throttle Body
- Product Attributes:
-
- Bore Diameter (mm): 75.00
- E-Waste: Yes
- FAQs:
- A Relearn Calibration Procedure Is Necessary After Installation Of Replacement Throttle Body.
- Are Your New Throttle Bodies The Same Design As Oe?
- Can I Purchase A Throttle Body With A Bigger Bore To Increase Horsepower And Improve My Throttle Response?
- Do All Throttle Bodies Have An Ice Breaker Mode For Extreme Cold Starts?
- Do You Sell Throttle Body Spacers?
- Is It Ok To Bypass The Coolant Hoses?
- Is There Anything That Has To Be Done After Installing The Replacement Throttle Body?
- No, Bypassing Of Coolant Hoses Is Not Recommended. There Are Cases Where We Sell Units Without Coolant Pipes, Because We Are Following Oe Supersessions Where The Pipes Have Been Removed And Instructions Are Provided For Rerouting Coolant Hoses.
- Not All Throttle Bodies Have This Feature Where The Throttle Valve Is Reversed From Its Normal Movement By The Controlling Module To Break Up Any Ice Formation Between The Throttle Bore And Valve. This Feature Is Based On Application.
- Swapping Your Throttle Body For One With A Bigger Bore Is Not Recommended. The Throttle Bodies We Sell Are Specific To The Application.
- The Electronic Throttle Body Is A Powertrain Component That Has A Plate, Motor, And Integrated Position Sensors Which Are Utilized To Regulate The Amount Of Air Entering The Engine By Opening The Throttle Valve To A Desired Angle Via Commands From The Veh
- The Most Common Failure In An Electronic Throttle Body Is The Integrated Throttle Position Sensor. The Etb Is Equipped With High And Low Voltage Reference Throttle Position Sensor For Redundancy. Either One Of These Sensors Could Fail Or Possibly Both.
- The New Electronic Throttle Body Is Designed And Manufactured To Meet Oe Manufacturer Standards.
- The Oe Throttle Body Has Coolant Hoses Attached. What’s The Purpose?
- The Purpose Of The Attached Coolant Hoses Is To Keep The Throttle Body Warm By The Transfer Of Heat From The Coolant To The Housing Preventing Moisture From Freezing Between The Throttle Body Bore And Throttle Valve During Extreme Cold Temperatures.
- The Throttle Body Is Also Utilized As Part Of The Cruise Control, Traction Control, Stability Control, And Pre-crash Systems, As Well As Other Systems That Require Engine Torque Management.
- We Do Not Sell Throttle Body Spacers Nor Do We Recommend The Use Of A Spacer.
- What Causes The Electronic Throttle Body To Fail?
- What Else Does The Throttle Body Control Other Than Idle Air Bypass And Acceleration Throughout Driving Range?
- What Happens When An Electronic Throttle Body Fails?
- What’s An Electronic Throttle Body?
- When An Electronic Throttle Body Fails, The Controlling Module Will Illuminate The Mil/ses/cel, The Module Will Then Activate A Fail-safe Mode Operation And Gradually Reduce The Engine’s Speed Back To An Idle Rpm.
- When Installing The New Electronic Throttle Body There Is No Need To Modify The Vehicle For Installation.
- Will I Have To Modify Anything On The Vehicle To Install Your New Throttle Body?
- Features and Benefits:
- 100% Computerized Testing Of Motor, Throttle Position Sensor And Articulation Ensures Reliable And Consistent Performance.
- Critical Components Used In Manufacturing The Electronic Throttle Body, Including The Housing, Throttle Plate, Position Sensors, Throttle Actuator Motor And Throttle Plate Return Spring Conform To Precise O.e. Dimensions.
- Each Throttle Body Is Tested For All Critical Functions, Including Response Time And Air Flow At Multiple Points, Ensuring An Optimal Fuel/air Ratio.
- Each Unit Is Guaranteed To Fit And Function Like The Original.
- Housing Color/Finish: Gray
- Housing Material: Aluminum
- Idle Air Control Motor Included: No
- Inlet Diameter (mm): 98.00
- Inlet Type: Round
- Outlet Diameter (mm): 75.00
- Outlet Type: Round
- Package Contents: Electronic Throttle Body, Instruction Sheet
- Product Condition: New
- Throttle Body Type: Electric
- Throttle Body Actuation Type: Electric
- Throttle Body Finish: Finished
- Throttle Body Inlet Shape: Round
- Throttle Body Material: Aluminum, Steel, Plastic
- Throttle Body Outlet Shape: Round
- Throttle Position Sensor Included: Yes
- All CARDONE 100% New Electronic Throttle Bodies are guaranteed to fit and function like the original due to our proprietary engineering standards. Each unit is built and tested as a complete assembly to ensure quick installation and reliable performance. All components match O.E., ensuring accurate air flow in all driving conditions and peak engine performance.