Shop Discount Door Hinges

Need info on replacing door pins 99 Sunfire 2 door

If you mean the door hinge pins they are a pill. Body repair shops have the best knowlege and tools for that. I need one myself and can't do it alone, T

Have numerous parts for sale and would like to know where to view or purchase parts catalogue. Only ones I can find are small parts would like one with motor transmission, etc.



(on edit - added a pic of the 36 Buick Series 40....... TomG 11-2008)

I need the hood hinge,and a door hinge for front door passenger side lower hinge.Hope you can help.
Thank You
Taco

1987
Chevrolet
S10 Blazer 4WD 2.8L


Hi, Im somewhat mechanically inclined but I need some help removing this door hinge and replacing it. This is a picture of the passenger side, the driver's side is what needs replaced but I do not want to open the door because the pin has been ripped from the hinge and it's a pain to shut the damn door.

Does this need to be heated up with a torch and then removed or something? I think it's welded on, which will probably be a pain. I'd really like to get this done; It's a pain in the butt getting in and out of the vehicle. Any help is greatly appreciated.

You can get just the pin and bushings for those which should be most of what is worn. Too late of course but these need greasing every oil change or go bad and are WELDED IN as you think. Horrible job to undo and line up drilling out unseen studs.


For the age if with new pin(s) available anywhere cheap with the bushings and it doesn't line up at striker well still it's bent or wore out the welded part.
At the age I think I'd go for bending the entire door hinge which can and will distort door or body to get real close but may flop UP not DOWN which you won't notice then. Body shops should know or do this AYOR for the perfection of the fit or damage to the door or body. Ask but do the hinge pins first (cheap) and see it that enough to keep you happy,


T

Hi, Tom Greenleaf

Thank you for the quick reply. The major problem is that the whole hinge needs replaced. I believe the whole door was bent back the wrong way or something, because where the pins slide through is completely busted. The door will not open without falling off. I have no choice but to replace the hinge. Any suggestions? Will I need a plasma cutter to get the thing off?

I appreciate the replies.

The driveside front door on a 2001 S-10 Blazer has the bushings worn out to the point where when you try to close the door you can see that its about a 1/4 of an inch out of alinement. How big of a job is it to repair or replace the bushings or the hinge?

Take a hard look to see if it's just the bushings - probably is as they are just a bronze that is pressed in. The aftermarket ones are better than OE in my opionion and dirt cheap. In full size GM trucks, hinges are welded (not a smart move GM) so you can't adjust the door so easy! Replacement takes some funky tools to pound out old one and the hard part is having to support the whole door for removal and re-installation making sure not to chip the hell out of it.

The tools and a good helper they are doable,

T

We have a 2004 Toyota Solara and all of a sudden the right door makes a sticking and thump sound when you open the door like it was in an accident?

Is this just a lube the door hinge and mechansims that hold it part open perhaps? If hinge wears down fender and door skin can rub - that means new hinge - tad early for a passenger's door for this car,

T