802.589.0911 Live Chat With Us

Finish Selecting Your Vehicle to Shop For Your Brake Pads

Choose a Year for your Audi 4000 's Brake Pads

  • 1984

Shop By Brand

The Following brands are available based on your search.

  • Monroe
    Monroe

Shop By Related Disc Brake Pad Parts

Shop below for all Disc Brake Pad related parts for your Audi 4000


Shop for Top Selling Genuine Audi 4000 Brake Pads

  • We Stock the following top leading brands, including Monroe
  • Constantly Updated Inventory of Audi 4000 Replacement Brake Pads Parts

We also have Brake Pads parts for other Audi models, including A4, A4 Quattro, A8 Quattro, Quattro, TT Quattro, 5000.

Monroe
1987 Audi 4000 Disc Brake Pad - Rear Monroe - Monroe Brakes Total Solution Semi-Metallic Brake Pads

P311-578B0FA    DX228  New

4D0698451B , 4D0698151J

Qty:
$34.51
Monroe Disc Brake Pad  Rear
  • OE Recommended
  • Monroe Brakes Total Solution Semi-Metallic Brake Pads
  • Suggested Purchase Quantity: 2
    • Most jobs typically require 2 of this item.
Brand: Monroe
Position: Rear
Additional Fitment Information:
Vehicle Position
1987 - Audi 4000 Rear

Latest Audi 4000 Repair and Brake Pads Installation Advice

CarJunky AutoAdvice

My Brakes

Showing 7 out of 7 Posts
Question From weirdobeff on My Brakes

So, I have this 1980 Audi 4000. The brakes recently started acting up. Like, when I was stopped at a light I would have to push down so far to stop but then it would get farther and farther as I was stopped. Then they stopped stopping. Its like...I have to push REALLY hard to make the car stop. All the way to the floor. All the pressure seems to be gone.
We drained the brakes and my brake pads are fine, as is my brake fluid.

Has this happened to anybody else? and any suggestions on what else to check?

Response From Double J

Hi

Has the entire system been checked for any leaks?
Definitely sounds like a hydraulic problem.
Why were the brakes "drained"?...I assume you mean bled.....was it for this problem?
CAn you pump up the pedal ?
What I mean is,if there is no leaks at all and the linings are ok,try pumping up the brake pedal and see if it firms up,if so,let off and reapply,it will probably start to go lower again...
Sounds like the master cylinder is faulty...has the symptoms of that....from what you describe..

CAUTION: DON'T CONTINUE TO DRIVE IT IN THIS CONDITION...IT IS UNSAFE ...

Response From weirdobeff Top Rated Answer

Yeah, I totally meant bled! :)
I don't know about the leak..i'll have to get that all checked out.
But if I pump the brakes they firm up for a few seconds. However, they go right
back down. Thanks for the caution. I was kind of hoping for more of a "Oh! All you gotta do is kick the car and it'll work!" but, thank you! I'll get all that checked out. :)

Response From dave284

Sorry for the lazy way of info........tough day

Response From weirdobeff

Hey No prob, Bob! Any info is good info. Lazy or not. :D

Response From Double J

Yep

Sounds like a bad master cylinder. But get it checked to verify no other leaks...

"So all you have to do is replace the master cylinder, bleed the system and THEN KICK THE CAR...LOL "

Let us know...

JIm

Response From dave284

http://www.autozone.com/az/cds/en_us/0900823d/80/04/f9/b4/0900823d8004f9b4/repairInfoPages.htm Try some of these test in this link as concern about the booster