802.589.0911 Live Chat With Us

Finish Selecting Your Vehicle to Shop For Your Axle

Choose a Year for your Mitsubishi 's Axle

  • 1997

Shop By Brand

The Following brands are available based on your search.

  • First Equipment Quality
    First Equipment Quality

Shop By Related CV Axle Assembly Parts

Shop below for all CV Axle Assembly related parts for your Mitsubishi


Shop for Top Selling Genuine Mitsubishi Diamante Axles

  • We Stock the following top leading brands, including First Equipment Quality
  • Constantly Updated Inventory of Mitsubishi Diamante Replacement Axle Parts

We also have Axle parts for other Mitsubishi models, including 3000GT, Diamante, Eclipse, Galant, Lancer, Mirage, Montero, Montero Sport, Outlander.

First Equipment Quality
2004 Mitsubishi Diamante CV Axle Assembly First Equipment Quality

P311-4E80762    W0133-1833219  New

Qty:
$84.47
First Equipment Quality CV Axle Assembly
  • New - Lifetime Warranty
Brand: First Equipment Quality
Additional Fitment Information:
Vehicle
2004 - Mitsubishi Diamante
First Equipment Quality
2004 Mitsubishi Diamante CV Axle Assembly First Equipment Quality

P311-5989D0D    W0133-1833220  New

Qty:
$85.70
First Equipment Quality CV Axle Assembly
  • New - Lifetime Warranty
Brand: First Equipment Quality
Additional Fitment Information:
Vehicle
2004 - Mitsubishi Diamante

Latest Mitsubishi Diamante Repair and Axle Installation Advice

CarJunky AutoAdvice

brake imbalace?????

Showing 2 out of 2 Posts
Question From Guest on brake imbalace?????

2000 mitsubishi diamante
160,000 miles 3.5L, automatic

i failed inspection for rear brake inbalance. 800lbs drivers side 300lbs pass side. first impression was failing rubber line from caliper to hard line. possible expanding? replaced the line. still failed again.

flushed the entire system with abs safe synthetic dot 3-4 fluid to make sure that it was not fluid breakdown. no air in any line double and tripple checked all fluid runs clean and air free. still not gripping to capacity. all other wheels at same capacity if not better on test.

removed caliper tested sliders and caliper function. the sliders are free moving and lubricated properly. the piston retracts and extends with no hangups. just not enough pressure. checked hard lines from rear axle to front of car. no leaks or breaks.

pedal is not rock hard in the top cycle but hard enough. secondary or 1/2" pedal hard to pass that point. front brakes are at 100% capacity
drivers side rear is at 100% as per printout
pass side rear is at 20-30% capacity. as per printout

pads are almost new and will be replaced again when they come in from mitsubishi. they show no signs of glazing or flaking due to exessive heat and i also soaked the pads with brake kleen just in case some oil may have gotten on them from the road or wherever.

when i put the brakes under heavy load the fronts lock up momentarily and the drivers rear does as well, however the passenger side rear has a bad what sounds like abs chatter. like a da da da da da da da da........ the abs light has not come on nore are the other wheels malfuntioning in abs mode. knowing that each wheel has an abs hard line from the modulator to the wheel and there is no brake balance adjustment i am at a loss.

i would think a bad abs pump modulator would throw an abs check light.

please help
thanks in advance

Response From Tom Greenleaf Top Rated Answer

Are these new pads just for while you wait for the OE new ones? Have they been put in on the old rotors without turning the rotors and given a chance to break in? BrakeKleen should dry but may take a while if you literally soaked pads in the stuff,

T